D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-895L => Topic started by: paul0363 on August 16, 2018, 03:00:20 PM
-
I can't get DNS-o-Matic to connect and update using the manual settings on the Dynamic DNS page.
I did a bit of searching around these forums and it seems to work on some routers and not on others (some appear to be working after a firmware fix). Is this a known issue with this router/firmware version (I'm using v1.21)?
I'm using the following settings:
Enable Dynamic DNS: Enabled
Status: Disconnected
Server Address: updates.dnsomatic.com Manual
Host Name: all.dnsomatic.com
User Name: username
Password: password
Time Out: 24 hours
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)
- What region are you located?
- Was a Factory Reset performed before and after any firmware updates then set up from scratch?
Link> >FW Update Process (http://forums.dlink.com/index.php?topic=42457.0)
- Was the router working before any firmware updates?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
Not sure if DNSoMatic is supported on this model router. Might try NoIP or DDNS. I know D-Links DDNS services should work on this model router...
-
The router is brand new and came with v1.2 firmware (which is the latest). I'm on Virgin Media cable with an Arris TG2492LG-VM hub set to modem mode.
DynDNS works OK but DNS-o_Matic will update both DYN and OpenDNS together.
I can't get D-Links DDNS to work as the sign up page on their website won't recognise the serial number of the router!!!
-
Any status on this? ???