D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: rjesse on August 09, 2012, 09:56:29 PM

Title: WLAN Partition Mode keeps enabling
Post by: rjesse on August 09, 2012, 09:56:29 PM

I'm trying to connect to from some wired clients on my network to some wireless clients.  With the wireless device connected I'm unable to ping it from the wired device.  If I restart the DAP-1360 the ping starts up, but after a while I'm unable to ping the wireless device again until I reboot the DAP-1360. Then the device is pingable for a while.

I have confirmed that WLAN Partition is not checked.  I'm running Version 2.11 Firmware, may router is an EBR-2310.

Title: Re: WLAN Partition Mode keeps enabling
Post by: FurryNutz on August 10, 2012, 07:08:37 AM

Do a factory reset and manually set up the DAP using it's web page. Save settings and restart. Check the DAP settings after, is the WLAN enabled after the restart?

Title: Re: WLAN Partition Mode keeps enabling
Post by: rjesse on August 11, 2012, 08:37:11 PM

I did the factory reset and put all my settings back.  It worked at first and then after a while I'm unable to ping any wireless devices again.

If I ping from the wireless device to the wired device then I can ping the other direction, (ie from the wired to the wireless).  But again after a while the ping stops.

Title: Re: WLAN Partition Mode keeps enabling
Post by: FurryNutz on August 13, 2012, 09:19:26 AM

I would contact DLink level 2 support and see why the WLan Partition keeps enabling after you've disabled it. Might be something between the DAP and EBR thats causing it. Keep us posted.

Title: Re: WLAN Partition Mode keeps enabling
Post by: rjesse on August 13, 2012, 09:52:16 AM

I'll contact them, typically never hear back when I contact support so we'll see if that will change this time.

Rick

Title: Re: WLAN Partition Mode keeps enabling
Post by: FurryNutz on August 13, 2012, 09:54:18 AM

I would call vs email. Keep us posted.

Title: Re: WLAN Partition Mode keeps enabling
Post by: rjesse on August 13, 2012, 12:02:08 PM

Unfortunately no time to sit on hold this week.

Title: Re: WLAN Partition Mode keeps enabling
Post by: FurryNutz on August 31, 2012, 01:06:48 PM

Any status on this?

Title: Re: WLAN Partition Mode keeps enabling
Post by: rjesse on August 31, 2012, 05:51:53 PM

Support hasn't really been of any help, their standard answer is to factory reset and reconfigure.  I have figured out that that problem has more to do with the Dlink  EBR-2310.  I bought another router and I have no problem pinging any WiFi devices, and now DHCP works properly from my WiFi clients.  Supports standard answer is to reset and rebuild the EBR-2310.  I've done that with no change.  I need to call back to support and see if they can figure out the problem, but it this point I've moved on.

Rick

Title: Re: WLAN Partition Mode keeps enabling
Post by: FurryNutz on August 31, 2012, 07:00:47 PM

Good luck.

Title: Re: WLAN Partition Mode keeps enabling
Post by: furlong on October 21, 2012, 05:35:20 AM

Update the wireless driver on your wireless client.