D-Link Forums

D-Link DSL Modem/Routers => Other DSL modem/routers => Topic started by: cscrutton on May 03, 2010, 05:49:40 AM

Title: 2740R firmware version 1.13
Post by: cscrutton on May 03, 2010, 05:49:40 AM
I found a new firmware version 1.13 for the above router. But for some reason the router will not update the firmware all I get is the error message below
Server Error
A file system error was detected on the RomPager server.

Return to last page

anyone have any ideas, I have contacted D-Link support via the self service portal but dont hold out much hope of a helpful response as my last query is still unanswered and that was sent two months ago :0(
Title: Re: 2740R firmware version 1.13
Post by: marvo on May 03, 2010, 10:12:44 AM
I looked at the log as I'm getting the same message and it appears that there's not enough non-volitile memory left to upload the rom update.

Is there a way to clear this so that the update can go on?
Title: Re: 2740R firmware version 1.13
Post by: Pondera on May 08, 2010, 06:19:46 AM
I found a new firmware version 1.13 for the above router. But for some reason the router will not update the firmware all I get is the error message below
Server Error
A file system error was detected on the RomPager server.

Return to last page

anyone have any ideas, I have contacted D-Link support via the self service portal but dont hold out much hope of a helpful response as my last query is still unanswered and that was sent two months ago :0(
Power off your DSL-2740R.
Disconnect the ADSL cable from RJ-11 port.
Power on your device.
Then re-try to update.
Title: Re: 2740R firmware version 1.13
Post by: aelorenzo on July 04, 2010, 02:51:37 AM
I have been testing this firmware. It does not have telnet remote managenet!

Am I right?

Thanks