D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-960L => Topic started by: Tunam on May 15, 2019, 04:59:03 PM
-
Hello,
I allow myself to post because I can't activate the motion detection of my 960l (Ver: A1 Fw ver : 1.06.01) via an HTTP request. Indeed, I have a domitic box jeedom on a raspberry. And it already controls a C2 foscam via the same process.
While browsing the internet, I found this address that works if I am connected to my camera via my chrome browser:
http://(username):(password)@192.168.168.1.xx:xx/config/motion.cgi?enable=yes&sensitivity=80&mbmask=FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
But I can't activate it via my jeedom. Do you have a solution for me? I made a mistake in syntax? or the camera just doesn't know how to do it?
Sorry about my English, I live in Belgium
Thank you for your answer.
Greg
-
Possible this Jeedom needs to be looked at. Contact the Mfr of this program. If the string works with the 960L from Chrome, and not this other app, then the issue is with this app.
Good Luck.