I have a new 601 vers. A1 F?W 1.01NA.
I tried the link from FuzzyNuts and read the disclaimer. However, page 10 of the 601 manual actually shows a similar "how to".
My lan allocates addresses automatically between 100 and 200. Through cat5e I connected an XPPro sp3 comp lan port to the #1 lan port on the 601. I can log into the 601 router and disable UPnP and Save. But each time I try to do step#3, uncheck DHCP Server and Save, it says "successful",counts down to 0 but when I click on "Continue" it won't. When I try to get back into the 601 router again I get a "no or low connectivity " message.
I have tried re-setting the router many times and then I can get back to the same step and it fails to continue each time at the same point.
All I am looking to do here is get a better AP signal in one corner of the house where fridge and cupboards block good reception from the DIR-655 and I have an ethernet connection available at that location to connect the 601 if I can fix this.
Any suggestions?