• April 13, 2021, 09:30:41 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Windows couldn't automatically bind the IP protocol stack to the network adapter.  (Read 21937 times)

impermanence

  • Level 1 Member
  • *
  • Posts: 1

When I ran the diagnostics on the adapter it came up with the following "Windows couldn't automatically bind the IP protocol stack to the network adapter." I found the solution on the Microsoft site posted by a user:

Go to:
Control Panel > Administration Tools > Computer Management > Services & Applications > Services.

Scroll down this list to find 'WLAN Auto Config'

Double click on 'WLAN Auto Config' On the general tab,  select from the start up type drop down menu,  select 'Automatic'. Under Service Status click on 'Start'. Then 'Apply' these settings and exit from all open control panel windows.

This should then allow Windows to set the required bindings.


Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49572
  • D-Link Global Forum Moderator
    • Router Troubleshooting

Thanks for sharing this information, however if the D-Link Drivers are installed, it should be able to connect and bind using D-Link wizard...by default the WLan Auto Config is usually enabled in windows.

Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.