• March 28, 2024, 05:05:00 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS 5222L Instal failure  (Read 3376 times)

Patrickthierry

  • Level 1 Member
  • *
  • Posts: 11
DCS 5222L Instal failure
« on: November 03, 2016, 11:58:08 AM »

Hi,
I bought a second DCS 5222L but I can't install it.
I tried with the WPS and Ethernet cable.
Using WPS I can't say much but the camera and router don't pair.
Using Ethernet cable, the green light does not stay solid but blinking every 3-4 seconds.
I tried for 2 hours now! First camera was install in a minute!!!

Any idea what goes wrong?
Logged

RYAT3

  • Level 10 Member
  • *****
  • Posts: 2254
Re: DCS 5222L Instal failure
« Reply #1 on: November 03, 2016, 12:12:37 PM »

Turn off first camera and try 2nd only.
Are these 5222lB's?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS 5222L Instal failure
« Reply #2 on: November 03, 2016, 12:31:13 PM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

What Mfr and model is the main host router?
What wireless modes are you using?

I recommend setting a static IP address ON the cameras outside of the main host routers default DHCP IP address pool as a troubleshooting step: 192.168.#.22 and .23  DHCP

Test cameras with uPnP and uPnP Port Forwarding both enabled on ALL cameras: DCS Cloud (L) Series Camera Configuration and Mydlink.com

Using the latest setup SW on mdlink.com?

Hi,
I bought a second DCS 5222L but I can't install it.
I tried with the WPS and Ethernet cable.
Using WPS I can't say much but the camera and router don't pair.
Using Ethernet cable, the green light does not stay solid but blinking every 3-4 seconds.
I tried for 2 hours now! First camera was install in a minute!!!

Any idea what goes wrong?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.