D-Link Forums
The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1224T => Topic started by: dmalec on July 21, 2009, 11:49:49 PM
-
Is it possible to work properly if the intrerswitch ports are configured as trunks, tagged vlan's members with stp enabled?
(http://www.kos.wsiz.rzeszow.pl/~dmalec/snet1.png)
-
Yes, however I would be careful to note that straight STP is not a VLANs best friend. Vanilla STP will fail to differentiate between VLANs and will ignore them in it's tree. MSTP is the correct pick if your equipment supports it.
Also, I would run your uplinks to two equidistant switches in your topology, not 2 to the centre of your ring, this concentrates your failure points unesccesarrily. sw2 and sw4 would be my choice. That said a true mesh will always be the surest method where available.