D-Link Forums

D-Link FAQ => Network Camera FAQs => Topic started by: JavaLawyer on February 27, 2013, 06:50:29 PM

Title: DCS-9XX - Fix for Visual Artifacts [Hardware Modification]
Post by: JavaLawyer on February 27, 2013, 06:50:29 PM
This procedure is designed to fix visual artifacts (e.g. horizontal lines) under low/no light conditions reported by multiple owners of DCS-930, DCS-930L, and DCS-932L cameras. The suspected cause is the omission of noise filtering of the CMOS signal under low light conditions. These image artifacts have resulted in reports of false positive motion detection events. This procedure involves opening the DCS-9XX case and soldering a capacitor on the camera. This procedure is a DIY hardware modification not supported or sanctioned by D-Link.

Procedure


Capacitor Solder Points
(http://sphotos-b.ak.fbcdn.net/hphotos-ak-snc6/207745_554054454605480_748019806_n.jpg)

Capacitor In Place
(http://sphotos-h.ak.fbcdn.net/hphotos-ak-snc6/206002_554054467938812_1782239365_n.jpg)

Results (Before and After)

Before Fix Is Applied (Note Horizontal Lines)
(http://i50.tinypic.com/2rr9bg0.jpg)

After Fix is Applied
(http://i46.tinypic.com/262xy4w.jpg)

Additional Resources

Disclaimer

The procedure described in this post is not sanctioned by D-Link, the thread poster, or content contributors for improving the performance or functionality of D-Link network cameras. Neither D-Link, the thread poster, nor content contributors warrant against damage to the camera on which this procedure is applied, property damage, or injury resulting from the application of this procedure. Individuals who choose to perform this procedure, do so at their own risk and will void the D-Link warranty for their DCS camera on which this procedure is performed.


Content for this solution submitted by forum members: mommono (http://forums.dlink.com/index.php?action=profile;u=61397) and Freeride (http://forums.dlink.com/index.php?action=profile;u=61946)