• March 29, 2024, 03:30:44 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS-932L will NOT save camera password  (Read 4726 times)

wavemaster

  • Level 1 Member
  • *
  • Posts: 2
DCS-932L will NOT save camera password
« on: January 26, 2015, 08:59:54 AM »

I have 3 DCS-932L cameras that I am trying to set up.

Found the reset button on the back and used a paperclip to reset the camera which it does after about 6 sec of holding the reset button down.

DVD with the Dlink Setup Wizard in the computer and I am at the Set your camera's password. Put in the password  and click on  next.

My router does not have WPS so it is connected by Ethernet cable to the network.

"Saving settings, please wait..... "

Comes back after a while with a message "there was a problem saving your settings, click next to try again"

Admin Id: admin which I cannot change.

Tried it many times no, still no luck.

Where to go from here?





Logged

RYAT3

  • Level 10 Member
  • *****
  • Posts: 2254
Re: DCS-932L will NOT save camera password
« Reply #1 on: January 26, 2015, 09:19:08 AM »

Log directly into the cameras firmware and change the password in there
Logged

JavaLawyer

  • BETA Tester
  • Level 15 Member
  • *
  • Posts: 12190
  • D-Link Global Forum Moderator
    • FoundFootageCritic
Re: DCS-932L will NOT save camera password
« Reply #2 on: January 30, 2015, 06:04:13 AM »

As RYAT suggested, you should try the Wed UI. Please see the following sticky post for detailed steps:
Network Cameras - Important Posts & Information
Logged
Find answers here: D-Link ShareCenter FAQ I D-Link Network Camera FAQ
There's no such thing as too many backups FFC