The Graveyard - Products No Longer Supported > DCS-942L

942L camera and NTP service problem

(1/1)

christianwis:
Hello everyone,

I have problems configuring the NTP service. It does not take the changes and always remains with date 2015.01.01

I have firmware 1.27 installed and I have already tried all the options. From NTP de America to Europe and do not take the changes.

I currently put "0.europe.pool.ntp.org" then save changes and then restart. However, it continues with the same date and time "2015.01.01"

Any suggestions?

Thank you very much,
Christian

FurryNutz:
Link>Welcome!


* What Hardware version is your DCS? Look at the sticker behind or under the camera.
* Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
* What region are you located?
What Mfr and model is the main host router?

I currently use ntp1.dlink.com. Try this setting.
Daylight savings enabled and Time Zone is Mouttain for my area.

Might factory reset the camera and set it up from scratch if adjusting the settings doesn't work...

Navigation

[0] Message Index