D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-130 => Topic started by: kvadim on July 06, 2015, 09:10:10 AM

Title: I have a problem with the DIR- 100
Post by: kvadim on July 06, 2015, 09:10:10 AM

Hi!
I have a problem with the DIR- 100 , if I want to download from the Internet a large file , then after a while I lost the internet . And the page of the router is also not possible to enter , to have all the time to reboot.

Hardware Version : B1
Firmware Version : v2.03(EN)

Title: Re: I have a problem with the DIR- 100
Post by: FurryNutz on July 27, 2015, 07:43:14 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What region are you located?
• Are you wired or wireless connected to the router?
• Has a Factory Reset (http://blog.dlink.com/what-is-a-reset-button-when-should-i-use-it) been performed?
• Was a Factory Reset performed before and after any firmware updates then set up from scratch?

  Link> >FW Update Process (http://forums.dlink.com/index.php?topic=42457.0)


Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?
• Is ISP Modem/Service using Dynamic or Static WAN IP addressing?
• What ISP Modem service link speeds UP and Down do you have? Link> Speed Testing Sites (http://forums.dlink.com/index.php?topic=48352.0)
• By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.
• Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended. (http://en.wikipedia.org/wiki/CAT6)
• Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values (http://forums.dlink.com/index.php?topic=53008.0)

I recommend that you have your ISP check the cabling going to the ISP modem, check signal levels going to the ISP modem. For DSL or Fiber service lines, ensure that the ISP is using good working phone or cable lines to the DSL modem and that the phone lines are filtered correctly. For cable Internet, RG-6 coaxial cable is needed, not RG-59. Check for t.v. line splitters and remove them as they can introduce noise on the line and lower the signal going to the ISP modem. I recommend having the ISP service physically check the lines going from the out side to the ISP modem. Connecting to the ISP modem could result in a false positive as the signal to the modem could be just enough to that point then adding on a router, could see problems. The router operation is dependent upon getting good data flow from the ISP modem and the modem is dependent upon getting good signal from the ISP Service.