D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-2330L => Topic started by: regmo0513 on July 01, 2014, 06:49:23 PM

Title: Cameras. All of a sudden just sending log to email no pics??
Post by: regmo0513 on July 01, 2014, 06:49:23 PM

I don't know what's going on. All of a sudden I am no longer getting any pics from either camera to my email.all I am getting is the log. Anyone know what's going on?

Title: Re: Cameras. All of a sudden just sending log to email no pics??
Post by: ceglia on July 06, 2014, 01:22:45 AM

Yeah, mine started behaving erratically like that as well, and now no longer sends ANYTHING.  used to send video clips, snapshots and logs.  I checked my Event Setup and noticed that my email settings (which previously tested fine) now fail the test.  WTF?  Haven't changed any settings.  Just stopped being able to send emails for some reason.

Check your email settings by running the test.  See if it still passes.

Title: Re: Cameras. All of a sudden just sending log to email no pics??
Post by: regmo0513 on July 23, 2014, 08:23:29 AM

i got it working for a while. As soon as i try to add an sd card, it fails again. I had support on the phone for over an hour and they had no answers!!! very frustrating!!!

Title: Re: Cameras. All of a sudden just sending log to email no pics??
Post by: ceglia on July 23, 2014, 09:49:53 AM

i eventually got it to work permanently by setting up the email account i get for free from my ISP (previously i was trying to get it to work using gmail and hotmail).  i honestly think that's the only way to get it to work reliably.

Title: Re: Cameras. All of a sudden just sending log to email no pics??
Post by: RYAT3 on July 23, 2014, 09:56:06 AM

If you are sending too many emails you may get blocked by yahoo Hotmail Gmail etc

Title: Re: Cameras. All of a sudden just sending log to email no pics??
Post by: regmo0513 on August 08, 2014, 06:32:11 AM

I finally fixed. I noticed that on motion detection settings, the info for email kept getting erased. (I believe that was the issue) now it's working. Thanks to all who wrote.