D-Link Forums
D-Link Enterprise => DGS-3630-Series => Topic started by: Teerasaklue on April 23, 2018, 10:05:07 PM
-
Firmware Version: DGS-3630-28SC Build 2.00.020 and DXS-3000-32S Build 2.40.046
I want to use port 3-4 be trunk together as 1 Link.
I config port 3-4 to VLAN 2.
Set Link Aggregation with Static mode on port 3-4 then VLAN be change to 1 and noway to config/correct.
The L3 switch, DGS-3630-28SC and DXS-3000-32S was the same.
What I do wrong or miss something, please suggest.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_01.jpg)
VLAN 2 had been assigned to Port 3-4.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_02.jpg)
Link Aggrregatin to Port 3-4 with static mode.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_03.jpg)
Show detail of Link Aggrregatin.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_04.jpg)
Back to VLAN list, Port 3-4 had been changed to VLAN 1.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_05.jpg)
Show VLAN interface list.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_06.jpg)
Show VLAN interface detail port 3.
April 25, 2018 5:00PM
I found the solution, it was below my nose. Yes....
At "VLAN interface list" scroll down to the bottom.
Port-channel List..... Now config VLAN as you wish...
CLI use = interface port-channel xx
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_10.jpg)
Show VLAN interface list.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_11.jpg)
Edit Port-channel interface.
(http://mis.ipc.kmutt.ac.th/doc/doc/figure/00287/la_12.jpg)
Back to VLAN list, Port 3-4 was corrected.
-
Once the port interface is part of a LAG group, any settings on their are ignored.
Go to VLAN Interface page and find "Port-Channel1" at the end of the list. Then edit to modify the VLAN settings.