The Graveyard - Products No Longer Supported > DIR-855L
Could dlink make a new firmware to add ipv6 pass-through ability for the router?
(1/1)
LynnField1366:
only in this way i can get the access to ipv6...
:(
FurryNutz:
Link>Welcome!
* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.
FYI:
This product has been discontinued.
Free support for this product will end on 05/01/2018
If you can't seem to get the 855 to work, you might try some DD-WRT or OpenWRT to see if they support this model router....
You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP.
FurryNutz:
Any status on this? ???
--- Quote from: LynnField1366 on March 07, 2017, 10:58:16 AM ---only in this way i can get the access to ipv6...
:(
--- End quote ---
Navigation
[0] Message Index
Go to full version