D-Link Forums

D-Link FAQ => Router FAQs => DD-WRT => Topic started by: whittyrfu on January 05, 2019, 08:05:02 PM

Title: can't flash DD-WRT on 800 series FAQ....
Post by: whittyrfu on January 05, 2019, 08:05:02 PM

Issues with loading DD-WRT on DIR-819 (AC750) and using DIR-810L rev.1 as suggested..... using many instructions including your FAQ....using most recent 2019 download (Brainslayer)...mac using safari and developer setting as IE 11 etc....followed step by step instructions....has not bricked router as I can still go back to OEM admin page via Http: and logging in

No status bar....when flashing DD-wrt i get warning:

"LAN IP address or Netmask change will result in failure of accessing this router.  If you changed the AP address of the AP, you should release and renew PC's IP for the succedent configuration.
Waiting time: 110 seconds"

Nothing else happens and I can still get back in via

I am using ethernet hook up via MacBook pro...safari...developer setup as IE 11.....doing flash on router right out of the box.....not hooked up to current network....just powered....and ethernet connection to laptop....loading most recent firmware from Brainslayer v.1 for DIR-810L in 2019 folder .....loading DD-WRT from factory before trying web flash....etc.  just like in instructions.

Title: Re: can't flash DD-WRT on 800 series FAQ....
Post by: FurryNutz on January 05, 2019, 11:03:56 PM
You'll need to post about this here:
https://forum.dd-wrt.com/phpBB2/ (https://forum.dd-wrt.com/phpBB2/)

The 810L has it's own FW. The 819 is probably different. Users on the forum should be able to help you with WRT FW. Need to ask them if there is specific 819 WRT FW. I don't see anything listed however. So it may not be supported as DD-WRT folks may have not developed anything for that particular model.

Good Luck.