Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[delphiman]

I am currently using DAP-1522 H/W A1 firmware 1.40 as bridge mode.

My PC connected to DAP-1522 via a cat5 cable and on my PC I configure my network card with IP 192.168.0.55 / 255.255.255.0 then I open my web browser and browse to 192.168.0
50 just fine.

So after I click Setup -> Wizard, then go through the steps to setup my DAP-1522 as a bridge to connect to a wireless signal from my Cisco router with wireless mixed mode, channel width 20Mhz, channel 6, WPA2/WPA mixed mode.

After all the setup, under status tab, it shows that Wireless radio enabled, Status Connected.

So I change my network card back to Dynamic IP. My computer des not get any I{ from the DAP-1522 and it show "Unidentfied Network" so my computer can't get on internet.

What am I doing wrong here? Why my DAP_1522 not grant any IP to my PC?

[FurryNutz]

How far way is the DAP from the main host router?

Try power cycling the main host router, DAP and PC after the configuration is set...