• April 13, 2021, 03:22:29 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Ball joint camera stand  (Read 3113 times)


  • Level 1 Member
  • *
  • Posts: 2
Ball joint camera stand
« on: July 06, 2011, 07:09:18 AM »

I need to tilt my DCS-932L downward further than is possible with the included ball-joint stand.  I understand I can adjust the position if I were to mount the stand on the wall or ceiling, but I would prefer not to do so.  Does anyone have any ideas of a replacement stand that that would work with this camera that would allow a deep tilt downward (from a counter to focus on a pet bed?


  • BETA Tester
  • Level 15 Member
  • *
  • Posts: 12190
  • D-Link Global Forum Moderator
    • FoundFootageCritic
Re: Ball joint camera stand
« Reply #1 on: July 06, 2011, 07:57:15 AM »

Here's a simple, low-tech solution.  Cut the top of a small 2"x4" wood block on a slant (i.e. wedge shape) and mount the camera on the slanted surface. This will provide you with the greater angle you're looking for.

The wood should be heavy enough to support the weight of the leaning camera.
« Last Edit: July 06, 2011, 08:46:58 AM by JavaLawyer »
Find answers here: D-Link ShareCenter FAQ I D-Link Network Camera FAQ
There's no such thing as too many backups FFC