D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-2230 => Topic started by: RYAT3 on December 06, 2013, 08:32:56 AM
-
Too many connections in use on 1 of my 2230s.
Might be time to reboot it?
It quit doing the auto icr a week ago and has been stuck in night mode. I don't see any unknown connections on my other 2230s.
-
Well.. started trouble shooting. .
Was able to connect to external ip on local network.
Also internal ip.
Log file kept timing out.
SD card stopped recording 12/3 at 4pm.
Pulled sd card to view.
Rebooted device through f/w. Can't reconnect.
Power cycled. . Still can't connect through wireless.
Going To attach to ethernet cable next and post update later.
Oh yeah reboot & power cycle appeared normal startup. .. ir cut on off. Power & led lights off.
So I just hope the network settings are only hosed for Some reason
-
Attached to ethernet cable. . Worked like a champ. Turned on wireless to my network. . Didn't work.. network loss/reconnect messages in Log.
Reentered password.. Pulled ethernet. .
Works.
Put sd card back in. . Set up 24x7 recording. . Everything looks good again.
Logs look fine. . It's like the camera just gummed up and gave up. F/w 1.10.
The Other 2230 next to it has shown no symptoms.
-
Thanks for the post. I had nothing to offer in response that would help you, but I have seen this once. I'm not sure how I got it into that state. Other than that it has been a stable (if buggy) camera.
Just wanted to let you know that some of us out there are reading even if we can't help.
-
Thanks. Hopefully it helps someone else out with a 503.
I found nothing in forums about 503 errors except on a router.
Thanks for the post. I had nothing to offer in response that would help you, but I have seen this once. I'm not sure how I got it into that state. Other than that it has been a stable (if buggy) camera.
Just wanted to let you know that some of us out there are reading even if we can't help.