D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => WBR-2310 => Topic started by: tester2 on July 13, 2012, 07:43:28 PM
-
hi guys i need your help, my d-link WBR-2310 wireless Router keep on Rebooting by itself, when i try 192.168.0.1 it is not connecting & not opening webgui of this Router.
can any body help me out, how to get this Router in Working Condition. or can any body let me know "How to j-tag this Router" to get work.
please help me out.
hopefully waiting for your replies.
-
Welcome! (http://forums.dlink.com/index.php?topic=41537.0)
What Hardware version is your router? Look at sticker under router.
What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on routers web page under status.
What region are you located?
Are you wired or wireless connected to the router?
What ISP Service do you have? Cable or DSL?
What ISP Modem do you have? Stand Alone or built in router?
What ISP Modem make and model do you have?
If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems.
To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged.
If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ.
Some things to try:
Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking
Ensure devices are set to auto obtain an IP address.
Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.
Enable uPnP and Multi-cast Streaming under Advanced/Networking.
Turn off all anti virus and firewall programs on PC while testing. 3rd party firewalls are not generally needed when using routers as they are effective on blocking malicious inbound traffic.
Turn off all devices accept for one wired PC while testing.
Check cable between Modem and Router, swap out to be sure. Cat6 is recommended. (http://www.networkcablingdirectory.com/articles/structured-network-cabling-id_1151.htm)
-
WBR-2310, Hardware ver:A1, i got Cable ISP stand alone Modem (no inbuilt router in this modem),
there is some hardware problem in this wbr-2310 Router Power light not ON, the other lights just on/off all the time. i mean keep on rebooting this router by itself.
-
Does the router reboot if you shut off wireless?
Have you tried swapping out LAN cables between the router and modem?
IF you disconnect the router from the ISP modem, and just leave a PC connected to the router, does it reboot then?
What FW version is currently loaded?