D-Link Wireless Routers for Home and Small Business > DIR-882
DIR-822 GUI cycles in browser
fiddletownrob:
After I access the router via http://dlinkrouter.local/Home.html it initially shows how many connected clients I have...shortly thereafter the count goes down to zero and the GUI recycles to the Admin sign-in screen. Any changes I've made to device names, reserved IP addresses, etc. are lost...I've tried using Chrome, Edge, and older IE...any suggestions?
Current Firmware Version: 1.10
Current Firmware Date: 2018-03-10T17:54:22
FurryNutz:
Link>Welcome!
* What region are you located?
* Has a Factory Reset been performed?
How many devices do you have connected?
fiddletownrob:
Hello,
I'm in California
Factory reset performed after upgrading to latest FW
I have between 17-20 devices connected at a time (cameras, weather station, pads, phone, range extender, printers, home automation hub), I'm not a gamer...
FurryNutz:
Was this working before or did you just upgrade the router?
I would try this, disconnect everything from the router accept for 1 wired PC.
Download the v1.10 FW file again to the wired PC.
Do a factory reset.
Using IE11 or FF, go in and re-load the same FW file.
After it loads, factory reset and set up from scratch. I might skip the set up wizard this time. Manually set up the SSID and Name.
Then add a few devices then see how it does...
Let us know if it still happens...
fiddletownrob:
Thank for getting back to me...this is (was) a new purchase to replace Netgear router the was going out.
I tried you suggestions then call Amazon for a replacement router, it arrived today with similar issues plus new ones:
1) as before, the connected devices count jumps all over then goes down to zero and the GUI recycles to the Admin sign-in screen
2) some of the reserved IP address don't get assigned to the correct device, therefore I can't access my home automation hub for instance
3) WPS fails to connect 3 of my devices, two are in the next room over from the router
My netgear router had none problems so I'm returning the routers to Amazon (once they get their site working again - LOL)
I thank you though for trying to help...
Navigation
[0] Message Index
[#] Next page
Go to full version