D-Link Forums
D-Link VPN Router => DSR-1000AC => Topic started by: scoody on September 06, 2017, 01:20:55 AM
-
Hi,
I installed without any trouble the DSR1000 FW 3.10_WW , but i only see the 5Ghz wifi 802.11n, the access point and profiles are also created in 2.4Ghz but i don't see them with my devices that are juste able to see the 2.4Ghz.
A few desktops are able to see the 5Ghz and it's working fine.
All is by default, i tried to change encrypt wep to wpa the WPA2 , tried to assigne some antennas but nothink works...
Regards
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your router? Look at sticker under the router case.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
Temporarily disable security on 2.4Ghz and see if any of the affected devices can see and connect to the 2.4Ghz radio. Then re-enable WPA and TPIK and see if devices can still connect. Then try WPA2 and AES only and test devices.
What channels are you using? 1, 6 or 11 is recommended for 2.4Ghz.
li]Any 2.4Ghz or 5Ghz cordless house phones or WiFi APs near by that maybe causing interferences?[/li]
[li]Any other WiFi routers in the area that maybe causing interferences? Link> Use a WiFi Scanner (http://forums.dlink.com/index.php?topic=48327.0) to find out. How many?[/li][/list]
-
Hi,
Hardware A1
Firmaware it was written in my message : FW 3.10_WW
Region : France
Without security : Same trouble
Channels : in automatic
No neighbourg at all .
Best Regards
-
I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email.
Let us know how it goes please.