D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-827 => Topic started by: Jvadood on January 11, 2012, 07:22:13 PM
-
I just got my Router today and all is setup, most everything seemed straight forward nothing I haven't delt with in the past etc. The internet is working great and things seem great wired. However WiFi is another story. It seems when I try to connect anything it will show up for about 1-2 seconds and then disappears, it also shows up live on D-Links Config page at the moment your doing the connecting. I also noticed some of the devices themselves some wont connect and others are in the same game with the on and off.
Heres what Ive got
Router DIR-827 H/W: A1 F/w 1.01
Itouch - sees device but refuses connection (nothing live in config screen during it)
2 Android Phones - connects about 1-2 seconds (also shows up live in config page for 1-2 seconds)
HP laptop - sees device but refuses connection (nothing live in config during it)
Things Ive read and tried...
Turn on DNS Relay under Setup/Networking. Done
Ensure devices are set to auto obtain an IP address. Done
Make sure uPnP is enabled under Advanced/Networking if you have this option. Done
What wireless modes are you using? 2.4GHz 11bgn, Channel Width 20, WPA2, WIFI Protected Enabled / 5GHz 11an, Channel Width 20/40, WPA2, WiFi Protected Enabled
Turn off Short GI and Extra Wireless Protection if you have it. Under Advanced/Advanced Wireless. Done
I am using a different SSID name then I had with my old router which was a netgear. I even tried using the same info my netgear had to see if it would work and it didn't. So I'm wondering what else I'm missing. Thank you all in advanced.
-
Check your messages.
-
Try setting up Mixed G and N modes on 2.4Ghz and try using WPA or WPA2 and TPIK only for Cipher. THen test with Auto TPIK and AES. Some devices don't support AES. Set 5Ghz to N mode only and AES only. If you don't have any devices that support 5ghz, you can turn it off.