The Graveyard - Products No Longer Supported > DIR-890L

Losing dhcp clients and reboots- lose smb

(1/5) > >>

mikey4u:
Have a problem for a couple of months now. I seem to lose DHCP clients on the connected list (Front page of router log in). Happens mostly at night or evening. Also the router often reboots. Is this a security problem. Should I install the last beta firmware patch.  Could something else cause this. Also I seem to get my smb shares randonly. Sometimes it is visable on my computer sometimes no. Starting to lose my mind.
ps last months added wifi light swiches. total connections average 25-30 DCHP client connections

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?

Internet Service Provider and Modem Configurations

* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
What devices do you have connected to the router?
What shares do you have configured? This on a PC or NAS?


* Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting and maintain consistency for applications that need to connect as well as mapped drives.
* Ensure devices are set to auto obtain an IP address.

Yes you can update FW: Link> >FW Update Process

mikey4u:
HARDWARE VERSION : A1
SOFTWARE VERSION: 1.20
REGION: CANADA
ISP SERVICE: CABLE
MODEM:HITRON CDA-RES
CONNECTED DEVICES: 2 NVIDIA SHIELDS, 2 GAMER DESKTOP, 2 LAPTOP,2 SAMSUNG PHONES, APPLE PHONE, LG PHONE, HTC PHONE, 15 WEMO LIGHT SWITCHS, RASPBERRY PIE, XBOX360, PLAYSTATION3, MATRICOM GBOX2.
SMB SHARES FROM: HARD DRIVE ON ROUTER(WORKS WITH MAPPED DRIVE), RASPBERRY PIE.
RESERVED IP: ABOUT HALF ARE RESERVED.
ALL SET TO AUTO OBTAIN IP ADRESS

The update is beta thougt. is it good or will it cause more problems

Any help would be greatly appreciated

FurryNutz:
You can update. If it doesn't work for you you can revert back to v1.20.

mikey4u:
Yes I will try the update as a last resort. Is there anything else I can do to resolve this.

Navigation

[0] Message Index

[#] Next page