D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => WBR-2310 => Topic started by: Darkpawn on July 07, 2009, 08:30:03 AM
-
Hello all.
I just recently upgraded the firmware on my router from 1.02 to 1.05 and now I cannot login to the admin page. I have already reset the router, and used a hard reset as well. Any ideas. Thanks.
-
did you tried to put nothing as password ???
user:admin
password:
it cleared when you install a new firmware along with all your settings...
-
Is your computer wired in router? Does it has a WLAN enabled while hardwired in router? You might need to disable your WLAN,possible that you are connected to somebody's network. Then try access the router's page again. If still fails, try a hardware reset.
-
This is part of our old "techniques" for such cases, but it may work :)
1. While the router is on, push the reset button at the back of the router for 10 seconds
2. once you reached 10 seconds and still holding up the reset button, try to turn the router off by pulling the power cord then count for more 10 seconds
3. after the last 10 seconds, turn the router on while still holding the reset button and wait for another 10 seconds before you release it
overall, you have 30 seconds to press the reset button. Most of the cases like this, we tend to resolve it using this method, try to give it a try and see how it goes :)
-
If you can get by the above issues, I suggest going back to firmware 1.04
I have found it the best of all firmwares except the DI-624 which I am reluctant to try.