• December 04, 2021, 03:59:39 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: set Link Aggregation with Static mode VLAN be change to 1 and noway to config.  (Read 6044 times)


  • Level 1 Member
  • *
  • Posts: 1

Firmware Version: DGS-3630-28SC Build 2.00.020 and DXS-3000-32S Build 2.40.046

I want to use port 3-4 be trunk together as 1 Link.
I config port 3-4 to VLAN 2.
Set Link Aggregation with Static mode  on port 3-4 then VLAN be change to 1 and noway to config/correct.
The L3 switch, DGS-3630-28SC and DXS-3000-32S was the same.
What I do wrong or miss something, please suggest.

VLAN 2 had been assigned to Port 3-4.

Link Aggrregatin to Port 3-4 with static mode.

Show detail of Link Aggrregatin.

Back to VLAN list, Port 3-4 had been changed to VLAN 1.

Show VLAN interface list.

Show VLAN interface detail port 3.

April 25, 2018 5:00PM
I found the solution, it was below my nose. Yes....
At "VLAN interface list" scroll down to  the bottom.
Port-channel List..... Now config VLAN as you wish...

CLI use = interface port-channel xx

Show VLAN interface list.

Edit Port-channel interface.

Back to VLAN list, Port 3-4 was corrected.

« Last Edit: April 25, 2018, 07:31:19 PM by Teerasaklue »


  • Technical Engineer
  • Level 3 Member
  • *
  • Posts: 139

Once the port interface is part of a LAG group, any settings on their are ignored.
Go to VLAN Interface page and find "Port-Channel1" at the end of the list. Then edit to modify the VLAN settings.