D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-885L => Topic started by: dg_102 on May 01, 2018, 06:58:24 AM
-
Hi,
I have a
Model Name: DIR-885L
Hardware Version: A2
Firmware Version: 1.20
My configuration is:
D-Link 885L A2 the main router connected to a fiber convertor in the basement.
Tp-Link as an access point on the top floor gateway using the DHCP from the main router.
On occasion devices connected to 2.4Ghz(D-Link) are dropped(even if they are 10 feet away) and they reconnect the access point located on the top floor.
Current configuration on the D-Link is:
SC enabled
Transition power is Medium
If I configure this on the Desktop GUI, the Guest Zone becomes active with the default dlink-guest and no password. I can connect to it and view it on a scanner. The only way to disable guest is to go on my phone and disable it from there. When using a scanner app from my phone I can see that the 2.4 GHz goes all the way up and then disappear for a few seconds. 5Ghz is rock solid does not show any of the 2.4GHz behavior.
Any advice on configuration would be greatly appreciated.
Thank you,
dg.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What region are you located?
So you have the DIR and TP-Link wireless running at the same time?
What channels are you using on the DIR and TP-Link? These need to be separate and far away channels from each other. DIR set to channel 11 and TP-Link set to channel 1 on 2.4Ghz. Set channel 36 on DIR and 149 on TP-Link on 5Ghz.
-
Region: Toronto, Canada
I set the DIR to 11 and 36 and the other AP router on 1 and 149 as suggested. I had turned off the Smart Connect so I had access to set the channel on DIR.
I will keep you posted if anything changed when I get home.
Thank you.
dg
-
;)
What is the distance between the DIR and TP-Link? Feet?
-
It is about 27ft going up through three wood floors.
-
OK. You might set power levels on the TP-Link to medium or low and DIR to High and test later on if you see other issues.