D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: tonewheelfreak on March 16, 2010, 08:44:56 AM
-
Does anyone know if my unit is compatible with a Belkin N+ router in wireless repeater mode??? For the life of me I can't get the unit setup...there's no browser access, only via the BASIC setup on CD which I have to start everytime to gain access to unit??? Help!
-
i have the same setup and get nothing from the repeater. the radio signal is flashing, both are set to the same channel, i am not getting a signal detectable by my phone or two laptops or the tivo or anything else. i think it's time to rma, i have wasted enough time with this. i thought the hawking repeater was bad but at least it worked for a little while
-
I finally sent my 1360 back for an exchange since I couldn't connect with unit thru browser, only with the setup application that came with cd...and even with that I couldn't go directly to ADVANCED setup but start ALL OVER AGAIN with basic setup.
With my new unit its the same thing??? What is going on DLINK SUPPORT GUYS??????????????
Never the less I'm still in progress to check it out at my repeater site with external antennas...I did get it to work as a plain AP for test purposes, but the REPEATER MODE is still to be seen?
-
I have had 2 dap-1360 units fail as a repeater with a dlink dir-655. I have used tech support and they have determined that both needed to be returned. The configuration seems to work but the repeater provides a very very weak (or no) signal. I had to pay for unit one return and now I am being hassled about the 2nd unit even though both needed to be returned at dlinks request. I would be careful about buying the 1360 as a repeater. has anyone had success with this unit as a repeater? :(
-
Ditto- Has anyone had success with this unit as a repeater?
I tried it with my DIR-655, and everything appeared to be set up properly, but none of my wireless devices seem to attempt to get a signal from the DAP. They keep trying to connect to my DIR in the house with little/weak signal.
-
Using DAP-1360 with DIR-655. Was getting strong signal from repeater, but no connectivity. Worked with D-link support and discovered that, in addition to setting up DAP-1360 wireless settings to match DIR-655, must also go to LAN settings in DAP-1360 and enter address of dir-655. This sttep is not called for by setup wizard or in manual.
Now have connectivity on Apple devices and one XP laptop. Another XP laptop still not connecting. All speeds are slow, however. 18.0 mps. Not happy.
-
Yet another disaster for the DAP-1360, and yet D-Link do nothing about it... If it were not for the fact that my DIR-655 has been brilliant and reliable, I would trash this company, but honestly, this unit is JUNK!