D-Link IP Cameras for Home > DCS series Network Cameras

DCS-950G: motion detection problem

(1/1)

maitrebart:
When I reset the netcam to default factory settings, I then setup the motion detection zones.

After a day or two (or either a few of visits in the motion detection page) I can no longer see the zones' window. Moreover, the OpenMSD monitor does not seem to work anymore.

The sensitivity and percentage values seems ok and to be saved though.

If I go reset the net cam to the default factory settings again, I have to reconfigure everything, including the motion detection zones. And again, after a day or two (or either a few of visits in the motion detection page) I can no longer see the zones' window.

Is anyone experiencing this?

Note: I have firmware 1.07 .

Navigation

[0] Message Index