D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => WBR-1310 => Topic started by: jman34756 on August 02, 2009, 03:55:08 PM

Title: Need help with my DWL-3200AP Revision b
Post by: jman34756 on August 02, 2009, 03:55:08 PM

I know this is not the right topic for this thread but I did not know where else to post, I got a used DWL-3200ap and I cannot access my GUI at all via 192.168.0.50. I reset the router many times, I have a ethernet cable going from the router to the ethernet port on my PC, I typed IPCONFIG /all and there is no default gateway to it. The router works fine with a cable modem pluged into it. Why can't I access the GUI? I want to set this up as a wireless bridge. I tried everything. Its got firmware 2.45 revision b. HELP!

Title: Re: Need help with my DWL-3200AP Revision b
Post by: Fatman on August 03, 2009, 08:50:25 AM

what is your IP when you are trying to access this AP connected directly to it?

Title: Re: Need help with my DWL-3200AP Revision b
Post by: cjr71244 on September 01, 2009, 12:04:02 PM

is there any way to get the serial number for a DWL-3200 when logged into it?
something like the command get macaddress
but would be get serialNumber

Title: hey not sure where to post this
Post by: unko on December 15, 2010, 02:16:51 PM

ok i need some serious help too, i have a dwl 3200ap not sure if it's revb or not im new to this type of networking. im trying to create a bridged wds AP with me and my neighbor soi can have wifi in my house instead of being stuck inone room where the connection is good.

here's my problem...EVERYTHING i can't even get to the web gui on my 3200ap i try using ap manager, but when i try to configure it says invalid IP.

it's my laptop hardwired though a switch than to the 3200ap... HELP PLEASE i don't feel like buying a new ap when i know i can get this awsome one working with your help