• March 19, 2024, 12:12:22 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Help on Setup: Can't get to click Configure  (Read 2337 times)

Zappy

  • Level 1 Member
  • *
  • Posts: 5
Help on Setup: Can't get to click Configure
« on: May 24, 2009, 05:58:35 PM »

Hi,

Hope someone could shine some light. After hooking up, click Refresh and the IP address was detected.

Once I click onto the IP address, the Configure button grey out immediately!

Try typing the IP address in IE but can't access to the admin web page.



Thank you for your kind attention.
Logged

lizzi555

  • Level 5 Member
  • *****
  • Posts: 605
Re: Help on Setup: Can't get to click Configure
« Reply #1 on: May 24, 2009, 08:19:25 PM »

What is your own network ? Is it in the same range as the address 192.168.0.32 of the DNS-323 ?

Try running Start -> Run -> CMD -> ipconfig /all

and see which address your network card connected to the DNS reverts back.
If it not starts with 192.168.0. you have to assign an address manually.
Logged

Zappy

  • Level 1 Member
  • *
  • Posts: 5
Re: Help on Setup: Can't get to click Configure
« Reply #2 on: May 24, 2009, 08:40:24 PM »

oh yes.... thank you so much. manage to change the IP address & format my hard disk etc.



Will try hooking up my wireless router to see if I could get connected up tonite.

Thank you for your reply.

Logged