D-Link Forums
The Graveyard - Products No Longer Supported => Other D-Link Products => DHP-306AV => Topic started by: fmevans on May 31, 2013, 07:07:03 AM
-
Dear All,
Have acquired a DHP-W307AV = DHP-306AV + DHP-W306AV , but they have come without the CD-ROM holding the Setup Wizard software for Mac OS X.
I have searched at the D-Link website and through search engines, but can't find anywhere to download this wizard.
Does anybody know where I can download it for Mac OS X?
Many thanks. :-\
-
Can you access any of the units on-board wizards with the Mac?
I would contact D-Link support directly and ask where the Mac SW can be obtained.
-
Thanks for the tips, but no, typing http://192.168.0.50 into browser leads nowhere (blank, white page).
Frustrating that D-link don't have the wizard to download from their site. Perhaps I'm missing something.
-
Please verify that your are using the correct IP address as some routers and APs don't use 192.168.0.50. Mostly APs use this address. Could be different with Power Line products. Contact D-Link support and ask. Good Luck.
-
Thanks FurryNutz.
Manual says to use http://192.168.0.50
...This just gives me a blank browser page.
D-Link have kindly sent the installation wizard software on CD-ROM, but unfortunately, that is for PC and I use Mac. When contacted, they say they do not have Mac software to do the job.
Will contact D-Link again to find alternative IP addresses to try to connect with the DHP-306AV. Apparently, http://192.168.1.50 can wok, but that does not work for me either.
-
Do you have a friend or family member close by that has a Windows platform PC?
Try a factory reset then attemp to connect to the DHP directly using a LAN cable. I think you'll need to input a static IP address ON your Mac to connect correct. Input 192.168.0.49 and 255.255.255.0.