• March 28, 2024, 09:45:56 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DGS-1210-28P: Vlan configuration in CLI  (Read 4429 times)

AlfredKOBA

  • Level 1 Member
  • *
  • Posts: 1
DGS-1210-28P: Vlan configuration in CLI
« on: May 18, 2017, 10:11:36 AM »

Hello,
please it's possible to configure the vlans in D-link switch?
I can't manage the switch in Web interface but i can ping it.
below the details i have in Telnet

DGS-1210-28P> ?
USEREXEC commands :
  config account admin password <passwd>
  config ipif System { ipaddress <ip-address> <subnet-mask> gateway <gw-address>
 | dhcp | bootp}
  config ipif System { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {enabl
e | disable}}
  debug info
  download { firmware_fromTFTP | cfg_fromTFTP} {<ipaddr>|<ipv6addr>} <path_filen
ame>
  logout
  ping <ip_addr>
  ping6 <ipv6addr>
  reboot
  reset config
  save
  show ipif
  show switch
  upload { firmware_toTFTP | cfg_toTFTP} {<ipaddr>|<ipv6addr>} <path_filename>
DGS-1210-28P>

Need your quick reponse.

Thanks.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DGS-1210-28P: Vlan configuration in CLI
« Reply #1 on: August 05, 2017, 10:35:57 AM »

Any progress on this?  :-\
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.