• October 08, 2024, 08:14:10 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: D-Link DAP-1155 (Factory Reset By Itself)  (Read 12926 times)

TamerRouby

  • Level 1 Member
  • *
  • Posts: 1
D-Link DAP-1155 (Factory Reset By Itself)
« on: June 20, 2020, 09:24:39 AM »
Hi All

I have the below model of D-Link access point, it keeps working fine for a while, but then it makes a factory reset by itself and make the wireless open with no password.
each time i tried to re-configure it, it works fine for a while, and repeats the same issue again.

please advice.

Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: D-Link DAP-1155 (Factory Reset By Itself)
« Reply #1 on: June 23, 2020, 07:46:55 PM »
Link>Welcome!

  • Link>What Firmware version is currently loaded? Found on the DAPs web page under status.

Is the DAPs FW been updated?

Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.