• April 16, 2021, 08:22:06 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Use NAS as 2 port bridge  (Read 2118 times)

ccamacho

  • Level 1 Member
  • *
  • Posts: 1
Use NAS as 2 port bridge
« on: September 12, 2019, 01:00:49 PM »

Hello,

First thanks for the forum as it's a very nice place with a lot of resources about D-Link devices.

The question is very simple,

Is it possible to connect the NAS in this way?
LAN1: Ethernet port (Wall port to router, Internet, local network).
LAN2: Laptop.

I tried different network configurations without any luck.

The idea is basically to reduce the number of devices as I will like to avoid installing another switch.

Thanks!
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49575
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Use NAS as 2 port bridge
« Reply #1 on: September 12, 2019, 03:36:50 PM »

The 2 ports on the back are used with Link Aggregation is enabled. Both ports would be connected to a LAG enabled router or switch in this configuration. If thats not enabled, then you'll need use either port and connect it to a switch.
Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.