D-Link Wireless Access Points For Business > DAP-2695

Auto channel while not activated

(1/2) > >>

erlinden:
I've been using this accesspoint for some time now and experiencing strange behaviour.

While setting the 5GHz channel on 100 (fixed), it's changing to different other channels (used to be 36, it is 60 at this moment). The gui is reporting channel 100 while inSSIDer is claiming to be another channel.

In the logging (don't know if it is related) it is showing an error "5G:Received Deauth:STA 00:22:FB:BF:A7:B8 (reason 1)".

After this error band steering is not working anymore. All devices except one are active on the 2,4GHz band.

Here some device information and settings:

Firmware Version:1.16 (EU)
Bought it in the Netherlands, assuming it's revA

Access Point
Auto Channel Selection Disabled
Channel 11 (2,4GHz), 100 (5GHz)
Width 20 MHz (2,4GHz), 20/40/80 (5GHz)
WPA-Personal, WPA2 Only, AES

Band Steering Enabled
Age 180
Difference 10
Refuse Number 3
Aging out Enabled
RSSI Threshold 30

FurryNutz:
Link>Welcome!


* What Hardware version is your DAP? Look at the sticker under the DAP.
* Link>What Firmware version is currently loaded? Found on the DAPs web page under status.
Can you test the DAP with Band Streering disabled and set a manual channel?

erlinden:
Checked my device...no 5GHz network at all.

Turned off band steering en restarted the DAP...5GHz available again on channel 100.
Will give an update tomorrow, as it seems to take some time before failure occurs.

FurryNutz:
 ;)

erlinden:
By turning off band steering and reducing the power on the 2,4GHz band it's working stable. No more strange channel switching anymore.

Do the guys from D-Link read on this forum as well?

Navigation

[0] Message Index

[#] Next page