D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: Gears on August 13, 2010, 02:31:24 PM
-
What up! guys I have a D-Link Dir-655 that i bought 2 months ago and for some reason the wireless Signal Strength gets weaker when I'm on my laptop but I am in same room where my router is and its sill weak what is the point in having 3 Antennas for if the wireless part of the router has weak signal.
http://www.flickr.com/photos/32230605@N03/4888776751/sizes/l/in/photostream/ (http://www.flickr.com/photos/32230605@N03/4888776751/sizes/l/in/photostream/)
-
A rate of 300 at 80% looks pretty good to me.
Most laptops run the antenna through the lid, so its angle can effect your reception.
-
A rate of 300 at 80% looks pretty good to me.
Most laptops run the antenna through the lid, so its angle can effect your reception.
O but when i had my linksys Wrt54g router i was getting 100% Signal Strength anywhere i go all over the house tho is the reason i'm not getting 100% signal strength is because i'm using wireless N.
-
O but when i had my linksys Wrt54g router i was getting 100% Signal Strength anywhere i go all over the house tho is the reason i'm not getting 100% signal strength is because i'm using wireless N.
Yea i was right its because i was using wireless N, when i use wireless G it went up to 100% where ever i went all over the house guys D-Link Dir-655 needs a new firmware update to fix wireless N signal Strength problems with range of wireless N wifi signal.
-
I have no issues when using N and achieving 100% even if I take my laptop outside.
-
I want to know how then what is did you do to get a 100% even if you go outside cause if i leave my room with my laptop it go to 60% or most of the times 50% so please tell me.
-
I want to know how then what is did you do to get a 100% even if you go outside cause if i leave my room with my laptop it go to 60% or most of the times 50% so please tell me.
Try environement: other AP signals, walls, obstructions, old DECT
Try: Antenna angulation.
Try: weak client side wifi
-
I find out way my signal Strength was so weak its because of Short GI when i turn it off my signal strength went up to 100%, when i turn it back on it was weak again.