Firmware | Hardware | WOL Works | Can set x.x.x.255 | ARP flush issue | Notes |
1.34NA | A3 | no | yes | yes | - |
1.33NA | ? | ? | ? | ? | - |
1.32NA | ? | ? | ? | ? | - |
1.31NA | ? | ? | ? | ? | - |
1.21 | ? | ? | ? | ? | - |
1.21SS | ? | ? | ? | ? | - |
1.20 | ? | ? | ? | ? | - |
1.11 | ? | yes | yes | ? | Sounds like lots of people stuck with 1.11 because WOL works there |
I have DIR-655, Hardware Version: B1, Firmware Version: 2.00NA, where the webpage will NOT allow me to use a Virtual Server with an address of 192.168.0.255. Specifically, when I enter that address and other settings you suggested, the response I get when I save the changes is that 192.169.0.255 is illegal! Additionally, I viewed the webpage code and can see where it blocks using 192.168.0.255. Apparently is does matter that I am using Firmware Version: 2.00NA for DIR-655, Hardware Version: B1.
Thank you, daedao! I will give it a try as it seems like a better solution.
It did not work. I still get the following message: The 4th range of IP address must be between 1 ~ 254.
It is possible that I did not correctly follow the instructions you provided.
daedao,
I get the same message as dagodfather. I don't think this hackfix works with the: Hardware Version: B1, Firmware Version: 2.00NA. Thanks for the info though.
daedao,
Check your PM. Hopefully you can find a solution. Thanks.
I got WOL to work for DIR-655, Hardware Version: B1, Firmware Version: 2.00NA
FIRST STEP
On SETUP, NETWORK SETTINGS, I changed the Subnet Mask to 255.255.255.128, where the Router IP Address was already set to 192.168.0.1
SECOND STEP
I then saved the change. My router hung and had to reset it, but the change occurred. Admittedly this is a pain in the ass, but blame D-LINK.
THIRD STEP
On ADVANCED, VIRTUAL SERVER, I added 192.168.0.127 as the device to wake-up EVEN THOUGH the actual IP Address of the PC I want to wake-up is 192.168.0.100. I am not an expert, but I believe ALL PCs on my local network that are setup to Wake-up On Lan, will in fact wake-up. I can live with that as ONLY my PC that is PERMANENTLY ASSIGNED 192.168.0.100 is set to wake up which is exactly what I want. BEFORE saving the changes on ADVANCED, VIRTUAL SERVER, I additionally set Name to Wake-On-LAN, Public and Private ports to 9, Protocol to UDP, Schedule to Always, Inbound Filter to Allow All. I then saved the changes.
I can't begin to tell you how many suggestions I tried that did NOT work! However the above procedure worked for my DIR-655, Hardware Version: B1, Firmware Version: 2.00NA.
If your unit is a NA router and has NA FW loaded then loading EU will present you with other problems as NA and EU FW are very different.NA router or EU router? I understand there are two different HW versions, A or B. Is there still another way to designate HW version?