Topic: Delay after motion is triggered before it looks for motion again (Read 2036 times)

BortFlancrest · « **on:** October 21, 2015, 07:43:50 PM »

I have a camera set to watch my front door. If I walk out the door, it triggers correctly and sends me a notification with images.
If I then return inside within about 30 seconds or so, nothing is triggered. After a couple of minutes it will then pick up motion again.

Is there a way to fix this so that the motion sensor resets after only 10 seconds or so?

FurryNutz · « **Reply #1 on:** October 22, 2015, 07:03:10 AM »

If you return in side, is there any motion going on? If there is no montion being detected after you leave the site of the camera, I would think that the camera is working correctly.

BortFlancrest · « **Reply #2 on:** October 25, 2015, 06:44:23 PM »

Well I walk outside and shut the door. So for a good 30 seconds or so there is no movement at all, then the door opens and I walk inside. This movement is enough to trigger the motion sensor off normally, however not if it happens within this short time-frame.

FurryNutz · « **Reply #3 on:** October 26, 2015, 07:26:33 AM »

Does it eventually start to trigger events?
Is the camera set up or a Static IP address?
Is uPnP and uPnP Port Forwarding enabled ON the camera?

D-Link Forums

News:

Author Topic: Delay after motion is triggered before it looks for motion again (Read 2036 times)

BortFlancrest

Delay after motion is triggered before it looks for motion again

FurryNutz

Re: Delay after motion is triggered before it looks for motion again

BortFlancrest

Re: Delay after motion is triggered before it looks for motion again

FurryNutz

Re: Delay after motion is triggered before it looks for motion again