D-Link Enterprise > DES-1210-Series
RSTP blocking
Marty:
Hi, hoping someone might give me some guidance on setting up three DGS 1210s in a ring configuration using RSTP.
RSTP is enabled on all three switches.
4 vlans are setup on ports 1-24 and tagged on 27 and 28.
Asymmetric VLAN is disabled
The 3 switches are interconnected on ports 27 and 28 in a ring so each switch connects to the other two.
The root switch Bridge Priority is set to 16384 to assure root election.
All other settings are default.
Issue - After a week of running both ports 27 and 28 on the root switch will go into blocking mode and disable the connection to the other two switches. I could very well have missed something but my searches haven't turned up anything.
Thanks
Gattsu:
It should not be doing that unless there is a new root bridge..
What is the model name and firmware version for all 3 switches?
Marty:
DES-1210-28P
Firmware 4.12.016
Hardware Ver C2
All three are the same with the same configuration minus the priority setting.
Thanks,
Marty:
Looks like I put this in the wrong section. It should be in the DES not DGS. Mabye a mod can move it?
Thanks,
Gattsu:
Are you seeing any TX/RX errors on ports 27-28?
Navigation
[0] Message Index
[#] Next page
Go to full version