D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => WBR-2310 => Topic started by: danno on December 26, 2010, 09:33:18 AM
-
We have a highpowered commercial router running as a wireless client in bridge mode. It has a static IP assigned at 192.168.69.11. The wbr-2310 is running as a DHCP client and the two are connected via the ethernet port on the bridge and the wired WAN port on the wbr-2310.
In this configuration we can access the internet, but we cannot address the bridge router. If I move the cable to the wbr-2310 LAN port, I can access the bridge and perform site survey functions, connect the bridge to an access point, but I cannot access the internet. If after connecting the bridge to an AP I move the cable back to the WAN port, I can access the internet but I can no longer access the bridge router via it's IP address.
Is there some way to forward LAN requests to the WAN port of the wbr-2310 without affecting the internet requests?
Do I need to put a switch between the bridge and wbr-2310?