The Graveyard - Products No Longer Supported > DIR-615

wifi devices are connected but with no internet access while Lan devices are ok

(1/1)

ryantew:
I have this same problem.

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Internet Service Provider and Modem Configurations

* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
What wireless devices do you have connected?

Wireless Configurations
Links>Wireless Installation Considerations and Managing Signal Congestion and Good Neighbour Policy

* What wireless modes are you using?
* 2.4Ghz Routers only: Try single mode G or N or mixed G and N?
* Channel Width set for Auto 20/40Mhz or try 20Mhz only.
* Try setting a manual Channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear. 13 for EU regions. Try channel 48 or 149 on 5Ghz.
* What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto TPIK and AES.
* What wireless devices do you have connected?
* Ensure any devices with WiFi adapter drivers are updated.
* Any 2.4Ghz or 5Ghz cordless house phones or WiFi APs near by that maybe causing interferences?
* Any other WiFi routers in the area that maybe causing interferences? Link> Use a WiFi Scanner to find out. How many?
* If you have any of these options, Try turning OFF or ON Short GI, WLAN Partition, Extra Wireless Protection and HT 20/40 Co-existence if you have it. Also testing with HT20/40Mhz Co-existence enabled will impact results as well. I prefer to use this option OFF. Recommended settings are default. Under Advanced/Advanced Wireless.
* Disable WPS Under Advanced/Advanced Wireless or Wireless settings.
* Enable WMM Enable Under Advanced/Advanced Wireless.

Navigation

[0] Message Index