D-Link Wireless Access Points For Business > DAP-2695

MultiSSID stops broadcasting when put on schedule

(1/1)

SUPERLID20:
Anyone have experience With this ?

I have enabled Multi-SSID on my access point, and all of them broadcast themself. Once i try to set a schedule on them they stop broadcasting.
I gave the schedule a name , choose the correct index and verified that the correct SSID shows up. I select the right day and even if i choose All Day(s) or enten correct time slot the SSID does not broadcast.

If i remove the Schedule , it starts broadcasting again.

I have checked that the time/date on the ap is correct.

SUPERLID20:
Some extra information. This happens running 1.20 firmware. After downgrading to 1.17 the problem is not longer there!

Gattsu:
Just tested this in my lab. Not seeing the issue.

My steps:
-Factory reset and updated firmware to 1.20.
-enabled MultiSSID
-Created 5 and 2.4 ghz SSIDs on the primary.
-Enabled and Set a schedule for 2.4 and 5.0.

Before retesting, make sure to factory reset and re-configure only these settings.

Navigation

[0] Message Index