D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-2310L => Topic started by: kiwi_mcer on June 10, 2014, 09:52:53 PM
-
I have 4 of these units running around my house, but one of them seems to be playing up lately. I have noticed that the unit will stop working after running for a few hours. Have tried everything, including a hard reset, re-flashing the firmware, etc, but to no avail!
Anyone have similar issues or have a solution? Otherwise, it looks like I may have to claim a replacement unit under the warranty period.
-
Try switching the microSD cards with the working cams
-
Sorry, I don't use any microSD's in my cameras. Have been recording directly using the Dlink DNR-202L.
That particularly camera is still playing up despite me removing the unit and plugging it into a completely different PoE switch. This rules out any issues with my PoE switch/supply or faulty cabling.
I have noticed that the camera seems to hang in the evenings, which may indicate that it's developed a fault when switching to IR/night mode or when the internal heater (yes there is one if you check the logs!) turns on in the evenings.
Looks like it's purely a DUD unit. I may have to get it returned for warranty replacement.
-
"I have noticed that the camera seems to hang in the evenings, which may indicate that it's developed a fault when switching to IR/night mode or when the internal heater (yes there is one if you check the logs!) turns on in the evenings."
I have this exact same problem! Well mine doesn't hang, just the frame rate drops to like 1-5fps and sometimes totally hangs for up to 10 seconds. I noticed this only happens in low-light mode. Ironically I shouldn't need the internal heater since I am in Arizona :)
-
"I have noticed that the camera seems to hang in the evenings, which may indicate that it's developed a fault when switching to IR/night mode or when the internal heater (yes there is one if you check the logs!) turns on in the evenings."
I have this exact same problem! Well mine doesn't hang, just the frame rate drops to like 1-5fps and sometimes totally hangs for up to 10 seconds. I noticed this only happens in low-light mode. Ironically I shouldn't need the internal heater since I am in Arizona :)
Raise your shutter speed from 1/8th to 1/30th
-
Where do I do that? I searched all of the settings and find no reference to shutter speed?