The Graveyard - Products No Longer Supported > DCS-2670L
DCS-2670L Flick Motion Detection Problem
FurryNutz:
Is the FW up to date?
This camera isn't marketed here in the USA so not sure about FW.
If the camera is set for day mode only and your still getting false flickers, then there seems to be a problem with the unit. Not sure if Canada or Brazil will support since your cross regional. I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this.
Link> Tech Support Contact Information
We find that phone contact has better immediate results over using email.
Let us know how it goes please.
BigKitty10:
Sorry to say that the new firmware does not work with my camera. I tried to update the firmware manually using the file provided. After 180 seconds, the camera resets and IE shows "Page cannot be displayed". I waited through the night, but was unable to access the camera even after 12 hours. (In videos of changing d'link cameras firmware, it took less than 5 minutes). So I unplugged then re plugged the camera and was able to access the webpage, but the firmware is still stuck at 2.00.02.
Here is what is displayed on the Information page
IP Camera Name: DCS-2670L
Time & Date: Sat Dec 22 16:33:34 2018
Firmware Version: 2.00.02
Hardware Version: A
MAC Address: B0:C5:54:41:94:A7
IP Address: 192.168.0.22
IP Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.1
Primary DNS: 192.168.0.1
Secondary DNS: 0.0.0.0
PPPoE: Disable
DDNS: Disable
Agent Version: 2.2.0-b25
FurryNutz:
Have you contacted Canada D-Link support about this?
v2.00.02 is the most current version of FW.
--- Quote from: BigKitty10 on December 22, 2018, 03:39:39 PM ---Sorry to say that the new firmware does not work with my camera. I tried to update the firmware manually using the file provided. After 180 seconds, the camera resets and IE shows "Page cannot be displayed". I waited through the night, but was unable to access the camera even after 12 hours. (In videos of changing d'link cameras firmware, it took less than 5 minutes). So I unplugged then re plugged the camera and was able to access the webpage, but the firmware is still stuck at 2.00.02.
Here is what is displayed on the Information page
IP Camera Name: DCS-2670L
Time & Date: Sat Dec 22 16:33:34 2018
Firmware Version: 2.00.02
Hardware Version: A
MAC Address: B0:C5:54:41:94:A7
IP Address: 192.168.0.22
IP Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.1
Primary DNS: 192.168.0.1
Secondary DNS: 0.0.0.0
PPPoE: Disable
DDNS: Disable
Agent Version: 2.2.0-b25
--- End quote ---
Navigation
[0] Message Index
[*] Previous page
Go to full version