D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: Benn on October 03, 2018, 11:28:55 AM
-
I have a D-Link DAP-1522 and it is blinking red and the wireless isn't working.
I have gone to 192.168.0.50 and I get the message:
UPDATING FIRMWARE
This page can be used to update the firmware of this device.
Instead of the Web-based Configuration Utility. How do I fix?
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)
- What Hardware version is your DAP? Look at the sticker under the DAP.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DAPs web page under status.
- What region are you located?
Did you power cycle the DAP then try again?
It seems your at a recovery page. Download the FW file to your PC then connect the PC back to the DAP and send the .bin file. Use IE11 or FF browsers with a wire connected PC.
-
H/W Ver.: B1 F/W Ver.: V2.02
USA
I did try unplugging the power and plugging it back it back but it still does the blinking red light problem.
-
Did you try resetting the camera? Hold a paperclip in the reset hole for 10-12 seconds and release. After it reboots you will have to set it up from scratch.