D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => WBR-1310 => Topic started by: Bill Tillman on July 21, 2010, 10:57:25 AM
-
I have an old DI-624 wireless router. Yes it's a very old model but I've updated the firmware and it works great. The router is setup inside my LAN firewall, that is it does not connect directly to the Cable modem from my ISP.
The WAN side of the router gets it's dhcp information from my main dhcp server on segment 10.0.0.0/24. The LAN side of the router is setup for 192.168.0.0/24 segment and it serves out IP addresses to my wireless clients and and computers which plug into the router via CAT5 cable.
I can access the 10.0.0.0/24 segment from the 192.168.0.0/24 clients but I cannot access the 192.168.0.0/24 clients from the 10.0.0.0/24 segment. This is not actually my problem but as you can see I haven't found a way to add a route to the router to tell the 10.0.0.0/24 clients where to look for the 192.168.0.0/24 clients.
I have now added mediatomb to the main server on the 10.0.0.0/24 segment and it streams media to my wireless PS3 player so I can watch movies on the big HDTV in the living room. Works great but only if the mediatomb server and the PS3 are on the same segment. I was hoping to find a way to add a route to the DI-624 router to tell the 192.168.0.0/24 segment where to find 10.0.0.0/24 or maybe just do port forwarding. So far all the attempts to port forward have not woked.
Can annyone offer advice on how to set up a route on the DI-624 ?