The Graveyard - Products No Longer Supported > COVR-3902-US

Can't get IPV6 working

(1/4) > >>

mloc3:
My ISP has native ipv6.  The covr wont pull the DNS automatically for some reason so I manually input googles.  Then I can't get it to assign ipv6 addresses.  It pulls a WAN address but that is it.

FurryNutz:
Have you enabled IPv6 and or set up any advanced SLACC or ULA configurations?
I don't have Ipv6 so I can't test this...

Whats the ISP modem Mfr and model #?


--- Quote from: mloc3 on January 18, 2018, 06:00:10 PM ---My ISP has native ipv6.  The covr wont pull the DNS automatically for some reason so I manually input googles.  Then I can't get it to assign ipv6 addresses.  It pulls a WAN address but that is it.

--- End quote ---

mloc3:
I am using the default settings.  I use an arris  SB6190.  IPV6 works fine with my google wifi router as well an my Netgear R8000p, just does not work with covr.

FurryNutz:
OK. I'll pass this on to D-Link for review.

I recommend getting into a different Arris modem. The 6190 has issues not related to this of course.  ::)

FurryNutz:
This issue has been reported to D-Link and is under review.  ;)

Navigation

[0] Message Index

[#] Next page