These are the steps (and info)
DCS-930L and 932L has severe noise problems in the picture in low/no light.
Someone found out the problem was that Dlink made a poor design and omitted noisefiltering the cmos signal in low light, thus introducing a lot of noise in the picture.
To rectify this, it is neccesary to solder a capacitor of 470 uF, 16 or 6.3volts between c38(NEGATIVE) and L8(POSITIVE) (I have used both, and both worked). For details, see pictures in this thread, AND BE CAREFULL TO GET positive and negative THE CORRECT WAY! Pry open the case with a screvdriver or thin hard plastic something to get to the inside, locate said points, solder. All other necessary info is in this thread.
DISCLAIMER; IF YOU OPEN YOUR IPCAMERA THE WARRANTY IS BYE BYE. DONT BLAME ME OR OTHER CONTRIBUTORS TO THIS THREAD IF YOU MESS UP. ANY AND ALL MODIFICATIONS TO YOUR IPCAMERA IS DONE ON YOUR OWN RISK.
Images of the mod;
https://www.facebook.com/photo.php?fbid=553598724651053&set=a.553598721317720.129413.100000027916196&type=3&theaterSomeone might want to copy the images from my facebook page to a more permanent place? They are free to use as You wish.