After installing my first DCS-2330L, I like the camera overall using wireless to connect to camera. But, there are something, mainly in firmware, that I think DLINK may improve. With the improvement, I believe that DLINK order will be A LOT better. And, you will get product referral and repeat customers.
1. Less disconnected errors. I need to unplug and plug the power to re-start. My friend, who got a LogicTech, has the similar failure and bought a switchable to re-cycle the power using cell phone remotely.
2. Firmware update through wireless, instead of Ethernet. It takes long time to re-connect the cable from the camera which was fixed on the wall. Note: LogicTech supports update from Wifi.
3. Reboot not to crash. It crashes about 50% chance right after reboot. I tried to configure rebooting daily to reduce the disconnected error. But, it does not work.
4. To record 3 second earlier before motion detection can work. I am not sure whether the camera worked before, but it lagged after I reset camera to factory default.
5. To reduce the incorrect motion detection. I think that some wrong detection are from the camera aperture changes. And, camera may mask off the detection at the aperture changes.
6. A new firmware update. I got 1.10.07 working with wireless. It was much better. It does not have reboot crash issue, and the 3 second pre-recording works well. But, it reports incorrect detection when aperture changes at sun light.